Ibanez SR405EPBDX Tropical Seafloor Burst Electric Bass

IBANEZ SR405EPBDX TSU

We are an authorized Ibanez Dealer. This bass is new with warranty and all included accessories/documentation. We have the Ibanez recommended MB300C hard case also available. We can ship your new bass best protected in the recommended hard case, otherwise it will ship in the original shipping material/container from Ibanez. Contact us for special arrangements.

SPECS
- neck type
  
  SR55pc Maple/Walnut neck
- top/back/body
  
  Poplar Burl topNyatoh body
- fretboard
  
  Jatoba fretboardWhite dot inlay
- fret
  
  Medium frets
- number of frets
  
  24
- bridge
  
  Accu-cast B505 bridge
- string space
  
  16.5mm
- neck pickup
  
  PowerSpan Dual Coil neck pickupPassive
- bridge pickup
  
  PowerSpan Dual Coil bridge pickupPassive
- equaliser
  
  Ibanez Custom Electronics 3-band EQ w/3-way Power Tap switch
- factory tuning
  
  1G,2D,3A,4E,5B
- strings
  
  D'Addario® EXL165 + .130
- string gauge
  
  .045/.065/.085/.105/.130
- hardware color
  
  Gold
NECK DIMENSIONS
- - Scale :
    
    864mm/34"
  - a : Width
    
    45mm at NUT
  - b : Width
    
    68mm at 24F
  - c : Thickness
    
    19.5mm at 1F
  - d : Thickness
    
    21.5mm at 12F
  - Radius :
    
    305mmR
- DESCRIPTION
  
  Guitar Neck Diagram
  a: Width of the neck at the nut
  b: Width of the neck at the fret position specified by the neck dimension
  c: Thickness of the neck at the first fret
  d: Thickness of the neck at the fret position specified by the neck dimension
  Radius: Radius of the fingerboard
CONTROLS

DESCRIPTION

With the bass held in the playing position, there are three small knobs closest to the lower edge of the body. Directionally, from the lower bout towards the neck knobs are treble boost/cut, mid boost/cut, and bass boost/cut. There are two larger knobs above these, closer to the bridge. The knob closest to the neck controls volume, and the knob next to it is the pickup balancer control. There is a 3-way power tap switch next to the balancer knob. When the switch is in neck position, the humbuckers are tapped. When the switch is in center position, the humbuckers are in series. when the switch is in bridge position, the humbuckers are in power tap mode, which is tapped with additional low end added.
FREQUENCY RESPONSE

DESCRIPTION

The bass boost/cut frequency curve has a peak at 20 Hz, the variable width becomes smaller toward the high range, and the variable width becomes zero at about 1000 Hz. The variable range becomes slightly larger in the high range than around 1000 Hz, but it becomes zero again near 5000 Hz. The variable range of the peak frequency is approximately ±15 dB. The treble boost/cut frequency curve draws a mountain-shaped curve with a peak at around 10,000 Hz and zero variable range around 100 Hz. The variable range of the peak frequency is approximately ±15 dB. The mid-boost/cut frequency curve creates a bell-shaped curve with a peak around 450 Hz, and the variable width becomes zero near 20 Hz and around 10,000 Hz. The variable range of the peak frequency is approximately ±15 dB.

916-939-0440 873 Embarcadero Drive, Suites 1 & 2, El Dorado Hills, CA 95762

Ibanez SR405EPBDX Tropical Seafloor Burst Electric Bass

SPECS

NECK DIMENSIONS

CONTROLS

FREQUENCY RESPONSE